1. Welcome Guest! In order to create a new topic or reply to an existing one, you must register first. It is easy and free. Click here to sign up now!.

Plugging Antec Mini P180 computer case to Asrock N68C-GS4 FX Motherboard

Discussion in 'New Build and/or New Hardware' started by Happygoluffy, Aug 5, 2018.

  1. Happygoluffy

    Happygoluffy

    Joined:
    Aug 5, 2018
    Messages:
    2
    Operating System:
    Windows 10
    Hi,
    I Just received a new motherboard and a new computer case. The components are all installed in the case. The only part of the installation missing is plugging in the wires from the case to the motherboard.
    The plugs are
    -HD Audio,
    -AC 97,
    -HDD Led,
    -Power Led,
    -VCC1
    -VCC2
    -Reset SW,
    -Power. SW
     
    Last edited: Aug 5, 2018
  2. DSTM (Dougie)

    DSTM (Dougie) Super-Moderator Super Moderators

    Joined:
    May 3, 2009
    Messages:
    8,258
    Location:
    SYDNEY AUSTRALIA
    Operating System:
    Windows 7
    allheart55 (Cindy E) and Tony D like this.
  3. Happygoluffy

    Happygoluffy

    Joined:
    Aug 5, 2018
    Messages:
    2
    Operating System:
    Windows 10
    Hi,
    Thanks for the link, I checked it before but was confused how to connect each wire. I'm not even sure if it's compatible as the computer case is more recent than the motherboard. If you could guide me through the installation of each wire, where to plug them that would be appreciated.
     
  4. DSTM (Dougie)

    DSTM (Dougie) Super-Moderator Super Moderators

    Joined:
    May 3, 2009
    Messages:
    8,258
    Location:
    SYDNEY AUSTRALIA
    Operating System:
    Windows 7
    Nearly midnight here. Will put something together tomorrow.
    The case is compatible.
     
  5. DSTM (Dougie)

    DSTM (Dougie) Super-Moderator Super Moderators

    Joined:
    May 3, 2009
    Messages:
    8,258
    Location:
    SYDNEY AUSTRALIA
    Operating System:
    Windows 7
    This is the Panel wire set up on your Motherboard.Note No 9 is a dummy pin.
    Always put the coloured wire to the left as per diagram.

    panel.png

    PW3.png

    PH1.png

    header 2.png

    The PWR switch and RESET Switches, are only momentary switches, and will work connected either way round.
     

Share This Page